Green when load is on | Red when load is off
Blinks Red once when responder does not acknowledge | blinks Green once if all responders acknowledge (can be disabled via software)
Blinks Green or Red during setup
Blinks Red to indicate traffic (must be enabled via software)
LED Brightness
Adjustable from off to 100% bright
Local On-Level
Adjustable from 32 fixed brightness levels or resume dim
Local Ramp Rate
Adjustable from 0.1 second to 5 seconds locally (0.1 seconds to 9 minutes with software)
Local control
Yes
Commands Supported As Controller
On | Off
Fast On | Fast Off
Begin Brighten | End Brighten
Begin Dim | End Dim
Commands Supported As Responder
On | Off
Fast On | Fast Off
Begin Bright | End Brighten
Begin Dim | End Dim
Incremental Brighten | Incremental Dim
Beep
Software Configurable
Yes
Ramp Rates (full-On to full-Off)
0.125 to 9 seconds if programmed locally,
0.125 seconds to 8 minutes if programmed remotely via software
RF Range
150 ft. (depending on your home’s construction)
Phase Detect Beacon
Yes
Insteon Device Category
0x01 dimmable lighting control (all frequencies)
Insteon Device Subcategory
2442-222 (915MHz) | 0x35
Mechanical
Mounting
Behind switch or above light fixture in single-gang electrical box
Wire Connections
Sense 1 (yellow): 24 AWG, 0.205mm²
Sense 2 (purple): 24 AWG, 0.205mm²
Max. Cable Size
4mm², 12 AWG (2.72mm diameter)
Min. Cable Size
1.5mm², 15 AWG
Screw Clamp Connections
Line
Load
Neutral
Neutral 2
Case Color
White
Set Button
Yes
Plastic
UV stabilized ABS+PC
Beeper
Yes
Beep On Button Press
Beeps when button is pressed or connected switch is tapped (must be enabled via software)
LED
1 RGB
Dimensions
1.8″ x 1.8″ x 0.7″(H x W x D)
Weight
2.52 oz
Operating Environment
Indoors
Operating Temperature Range
32° to 104°F (0° to 40°C)
Operating Humidity Range
0-90% Relative Humidity
Storage Temperature Range
-4° to 158°F (-20° to 70°C)
Electrical
Voltage
100VAC to 240VAC
Frequency
50/60Hz auto-detected at power-up
Load
Min. 5W, Max. 200W
Load Types
Incandescent
Hardwired Remote Control
Yes, either latching or momentary switches supported
Retain All Settings Without Power
Yes, saved in non-volatile EEPROM
Standby Power Consumption
<w< td=””></w<>
Safety Approved
ETL, CE, C-Tick
Certifications
FCC, UL, IEC, EN
FCC ID
SBPMM01
Reviews
There are no reviews yet.
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.