Sale!

$53.99 $49.99

  • Wires in behind your existing switches or fixtures
  • Sense wires allow for control via a connected, hard-wired switch
  • Minimum 5W, Maximum 200W
  • Compatible with latching, single momentary and dual momentary switches
  • Programmable on-level and ramp rate
  • This product is an Insteon Dual-Band device

Out of stock

Categories: ,
General
Manufacturer Insteon
Manufacturer Product No. 2442-222
UPC 813922012705
Warranty 2 Years
Insteon Features
Insteon Controller and responder
Maximum Links/Scenes 400
Load Brightness Levels 32 locally (256 with software)
Status LED Green when load is on | Red when load is off
Blinks Red once when responder does not acknowledge | blinks Green once if all responders acknowledge (can be disabled via software)
Blinks Green or Red during setup
Blinks Red to indicate traffic (must be enabled via software)
LED Brightness Adjustable from off to 100% bright
Local On-Level Adjustable from 32 fixed brightness levels or resume dim
Local Ramp Rate Adjustable from 0.1 second to 5 seconds locally (0.1 seconds to 9 minutes with software)
Local control Yes
Commands Supported As Controller On | Off
Fast On | Fast Off
Begin Brighten | End Brighten
Begin Dim | End Dim
Commands Supported As Responder On | Off
Fast On | Fast Off
Begin Bright | End Brighten
Begin Dim | End Dim
Incremental Brighten | Incremental Dim
Beep
Software Configurable Yes
Ramp Rates (full-On to full-Off) 0.125 to 9 seconds if programmed locally,
0.125 seconds to 8 minutes if programmed remotely via software
RF Range 150 ft. (depending on your home’s construction)
Phase Detect Beacon Yes
Insteon Device Category 0x01 dimmable lighting control (all frequencies)
Insteon Device Subcategory 2442-222 (915MHz) | 0x35
Mechanical
Mounting Behind switch or above light fixture in single-gang electrical box
Wire Connections Sense 1 (yellow): 24 AWG, 0.205mm²
Sense 2 (purple): 24 AWG, 0.205mm²
Max. Cable Size 4mm², 12 AWG (2.72mm diameter)
Min. Cable Size 1.5mm², 15 AWG
Screw Clamp Connections Line
Load
Neutral
Neutral 2
Case Color White
Set Button Yes
Plastic UV stabilized ABS+PC
Beeper Yes
Beep On Button Press Beeps when button is pressed or connected switch is tapped (must be enabled via software)
LED 1 RGB
Dimensions 1.8″ x 1.8″ x 0.7″(H x W x D)
Weight 2.52 oz
Operating Environment Indoors
Operating Temperature Range 32° to 104°F (0° to 40°C)
Operating Humidity Range 0-90% Relative Humidity
Storage Temperature Range -4° to 158°F (-20° to 70°C)
Electrical
Voltage 100VAC to 240VAC
Frequency 50/60Hz auto-detected at power-up
Load Min. 5W, Max. 200W
Load Types Incandescent
Hardwired Remote Control Yes, either latching or momentary switches supported
Retain All Settings Without Power Yes, saved in non-volatile EEPROM
Standby Power Consumption <w< td=””></w<>
Safety Approved ETL, CE, C-Tick
Certifications FCC, UL, IEC, EN
FCC ID SBPMM01

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Related products